1. Introduction

    1. This document sets out the conditions for the use of:

      1. The Eurosafe UK CDM Competent Logo by Eurosafe UK and its affiliates or subsidiaries;
      2. The Eurosafe UK CDM Competent Logo by accredited suppliers

    2. Where applicable, these conditions shall be met by Eurosafe UK and by all Eurosafe UK CDM Competent accredited suppliers, including those outside the United Kingdom.

    3. Eurosafe UK CDM Competent accredited suppliers shall take all reasonable steps to ensure that their use of the Eurosafe UK CDM Competent Logo complies with these conditions on the use set out in this document.

  2. Forms and Display of the Eurosafe UK CDM Competent Logo

    1. The Logo shall be displayed only in the appropriate form, size and colour detailed in this document.

    2. Accredited suppliers shall base all reproductions of the Logo on the master versions as shown at the end of this document which are available as electronic files from Eurosafe UK. The images included at the end of this document are for illustration only. Redrawn approximations shall not be used.

    3. The Logo may be displayed on stationery:

      1. only if the title or logo of the accredited supplier is also shown;
      2. with no more prominence than the title or logo of the accredited supplier;
      3. and not more than once, regardless of whether the supplier has multiple accreditations

    4. Where the Logo is reproduced electronically the following applies:

      1. the Logo is to be reproduced so that infilling does not occur;
      2. degradation and/or distortion of the Logo graphic is avoided;
      3. electronic versions of the Logo shall be obtained from Eurosafe UK.

    5. Embossed, relief, or die-stamped versions may be used. The Logo may also be reproduced as a watermark.

    6. The Logo shall normally have a minimum height of 25 mm. Any enlargement or reduction shall retain the same proportions as those of the masters reproduced in this document.

    7. In exceptional circumstances, which are usually dictated by reason of space limitation or cost, the Logo may be reproduced at a reduced height, but the next paragraph must be satisfied.

    8. Irrespective of the height of reproduction, the Logo must, in the opinion of Eurosafe UK, be legible, with no infilling.

    9. When the Logo is printed on an unfolded portion of stationery sized no greater than A4, it shall be displayed in a size no larger than 50 mm high. On larger portions of unfolded stationery the size may be proportionately increased.

  3. Use of the Eurosafe UK CDM Competent Logo

    1. Only Eurosafe UK and suppliers accredited by Eurosafe UK may use the Logo on stationery, quotations for work, reports and certificates, websites and brochures, and other items relevant to the accredited organisation's accredited activity, subject to the conditions set out in this publication.

    2. An accredited supplier is defined as a supplier which has successfully completed the Eurosafe UK CDM Competent assessment process, and received a certificate from Eurosafe UK notifying them of their accreditation.

    3. The Logo may only be used for the duration of the supplier's approval period - if the supplier allows their approval to expire, they must cease all usage of the Logo.

    4. The Logo shall not be used in such a way as to suggest that Eurosafe UK has certified, or approved, any product or any service supplied by an accredited supplier, or in any other misleading manner.

    5. The Logo shall not be used in any way that might mislead the reader about the status of an accredited supplier.

    6. Any use of the Logo that might contravene the conditions laid down in this document shall be referred to Eurosafe UK.

    7. The Logo shall not be used in such a way as to imply that Eurosafe UK accepts responsibility for activities carried out under the scope of accreditation.

    8. It is the responsibility of every accredited supplier to minimise the risk of a client/reader being misled as to the extent and limitations of its Eurosafe UK CDM Competent accreditation, whether it be in relation to quotations for work, work being undertaken, results being reported, the use of sub-contractors or in any publicity material used for advertising activities or services.

    9. Reports and certificates issued by accredited organisations that contain results and outcomes from accredited activities and non-accredited and/or subcontracted activities shall readily distinguish the activities that are covered by the organisation's accreditation and those that are not.

  4. Publicity Materials

    1. Eurosafe UK accredited suppliers are entitled to incorporate the Logo in publicity material that refers to accredited services, provided that the conditions relating to their reproduction contained in this document are met.

    2. Eurosafe UK accredited suppliers may display the Logo on internal walls and doors and on exhibition stands.

  5. Vehicle Labels

    1. Eurosafe UK provides ready-made adhesive labels featuring the Logo which may be affixed to vehicles belonging to the accredited supplier. The supplier may use these, provided that the following conditions are met:

      1. Only one label may be used per vehicle side. For the avoidance of doubt, sides are defined as front, back, left and right;
      2. Only the labels obtained from Eurosafe UK may be used - suppliers shall not use approximations or reproductions made either in-house or by a third party, except with the prior written approval of Eurosafe UK;
      3. The label may not be obscured by another label

  6. Suspension, Expiration and Termination of Accreditation

    1. Upon the expiration or suspension of relevant Eurosafe UK CDM Competent accreditation, accredited suppliers shall immediately cease to issue certificates, reports and quotations for work displaying the Logo and this shall include the removal of logos displayed on websites.

    2. Upon termination of Eurosafe UK CDM Competent accreditation, accredited suppliers shall immediately cease distribution of all items on which the Logo is displayed and this shall include the removal of logos displayed on websites.

  7. Colour Table

    1. Eurosafe UK provides ready-made adhesive labels featuring the Logo which may be affixed to vehicles belonging to the accredited supplier. The supplier may use these, provided that the following conditions are met:

      Colour Pantone RGB CMYK Hex Sample
      Logo Colour Pantone Solid Matte 485 M 222, 39, 35 7, 98, 100, 1 #DE2723  
      CDM Comptetent Colour Pantone Process Black 0, 0, 0 65, 68, 67, 90 #000000  
      Eurosafe UK text colour Pantone Solid Matte 416 M 137, 138, 129 48, 39, 26, 6 #898A81  

Download Logos

The following are high-quality logos (2000x2000 pixels) which may be downloaded and used in accordance with the above terms and conditions: